Weidmuller AC SMART ECO Bedienungsanleitung Seite 95

Setting the maximum asymmetrical phase current
Prerequisite
You must be logged in as an Admin. Electrician only!
The maximum charging current must be limited (Max current asymmetrical)
for vehicles that do not use all three phases. The maximum asymmetrical
current is dependent on the domestic installation and the locally applicable
specifications and provisions.
► Click Config/General.
► Change the value.
► Click Save.
Adjusting the LED brightness
► Click Config/General.
► Change the value.
► Click Save.
Adjust LED inactivity
The LED inactivity function can be used to switch off the status LED whenev-
er the status of the EV charging box does not change during a defined time
period, for instance during the charging process. Once the status of the EV
charging box changes, the status LED is active once again and the timer is
reset. The function LED inactivity is activated upon delivery.
► Click Config/General.
► Activate LED inactivity.
► Change the value.
► Click Save.
Setting up user authentication
Each EV charging box can be operated without user authentication (Free-
mode). User authentication can be configured in order to prevent unauthor-
ised use of EV charging boxes. The following authentication methods are
available:
– RFID
– Website, Modbus RTU, Modbus TCP and AC SMART App
– Digital input (via external switching device)
The EV charging box is set up as follows as a default:
– ECO: charging without authentication (Freemode is activated)
– VALUE and ADVANCED: charging with authentication (Freemode is
deactivated)
► Click Authorisation.
► Activate the desired function (Allowed authorisations).
► If you are using the EV charging box with a backend, assign a Local
authorise tag.
► Click Save.
Networking and configuring the EV charging box
Operating instructions – AC SMART 95