Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
Troubleshooting
The status LED indicates faults in the operation of the EV charging box. If the EV charging box is
connected to the AC SMART App or accessible via the web server, then detailled fault descriptions and
troubleshooting measures will be listed in the AC SMART App and in the web server.
12.1 Status LED
LED state
The LED is not illuminated. The function LED inactivity
The LED is illuminated
red briefly and you will
hear a descending se-
quence of tones.
The LED will be illuminated
continuously red.
The LED flashes red.
► If the fault cannot be corrected with the measures described, contact Weidmüller Service or commis-
sion an electrician to correct the fault.
108
Operating instructions – AC SMART
Possible cause
is active and the status LED
went out after the set time.
The RFID tag is not
registered.
The charging process was
started with another RFID
tag.
There is an error associated
with the connected vehicle.
There is an error.
Recommended action
► Check the settings in the AC SMART App
or the web server.
► Commission an electrician to correct the
fault.
► Hold a registered RFID tag in front of the
interaction surface to start a charging
process.
► To stop a charging process, hold the same
registered RFID tag in front of the interac-
tion surface with which you released the
charging process.
► Disconnect the charging plug from the
vehicle and the EV charging box.
► Connect the vehicle to the EV charging
box once again.
► If the error is still present, start the
AC SMART App or the web server.
The error is displayed.
► Follow the troubleshooting instructions ,
see Page 109.
► Switch off the residual current circuit
breaker.
► Switch the residual current circuit breaker
back on after 10 seconds.
► If the error still occurs, start the
AC SMART App or the web server.
The error is displayed.
► Follow the troubleshooting instructions,
see Page 109.
Werbung
