HBM espressoDAQ DQ401 Bedienungsanleitung Seite 24

24
If no transducers are plugged in at the transducer connector, then:
DQ401:
 ... the measured value is in positive overload (for voltage
channel only)
 ... the TEDS chip or the jumper cannot be read/detected.
The relevant LED glows red.
*>
DQ430:
 ... the bridge excitation voltage is in overload
 ... the TEDS chip or the jumper cannot be read/detected
The relevant LED glows red.
*>
DQ809:
 ... the measured value is in positive overload
The relevant LED glows red.
*>
The OVFL symbol is displayed in catman
*>

A2888−1.1 en/de
Starting up