Troubleshooting; Error Messages / Operating State (Led Display) - HBM espressoDAQ DQ401 Bedienungsanleitung

66
11

Troubleshooting

Before actually starting to measure, you should check your system.

11.1 Error messages / operating state (LED display)

For the system to be ready for measurement, the LEDs on the transducer and
system sides must indicate the states described in Sections 8.1 and 8.2.
If this is not the case, follow the instructions under "Remedy" in the tables be-
low.
SYS OUT connection:
LED Status
B OFF
A red, flashing
A red, constant
A red- , flas-
green
hing
Transducer inputs:
Status
All LEDs flashing red
LED glows red
LED glows orange
Significance
inactive
Configuration error (e.g. invalid calibration
data)
Serious error
Internal error
No adjustment data present :
send the module to HBM
No transducer plugged in,
− TEDS is present, but is not written
− Jumper present (1-wire lead)
Transducer present, but has Overflow or Underflow status
Significance
faulty TEDS
no jumper
cable breakage
Troubleshooting
Remedy
Send the module
to HBM
1. Restart
2. Send the mo-
dule to HBM
Send the module
to HBM
A2888−1.1 en/de