Plug-In Sequence - HBM espressoDAQ DQ401 Bedienungsanleitung

26

5.4.1 Plug-in sequence

1. Connect the power supply to the USB HUB and turn on the voltage
(230 V)
The green Power LED on the back of the housing must light up
Power supply
Fig. 5.5: Connecting the power supply
2. Connect the PC and the other modules
Standard USB cable,
1-USBHUB-4A
Power supply
Fig. 5.6: USB HUB connection with 4 modules
Following the correct connection sequence stops the USB HUB disconnecting
one or more of its channels (and thus the corresponding espressoDAQ mo-
dule) from the voltage supply, so that when this module is selected, it is not
recognized by the relevant software (such as catman
1. 2.
USB
1-KAB286-2
USB
USB
USB

Starter).
Starting up
A2888−1.1 en/de