Service And Maintenance; Accessories - IKAR HRA Prüfbuch Und Gebrauchsanleitung

14. Fall arrest blocks must not be used for securing persons working above bulk goods or
similar substances where people can sink in
15. As necessary, but at least every 12 months, fall arrest blocks with recovery mechanism
must be inspected by the manufacturer or by persons trained and authorised by the
(
manufacturer
10
the product. The effectiveness and durability of the fall arrest block depends on regular
inspection.
16. Observe DGUV R 112-198 and DGUV R 112 - 199 (fall (rescue operation)).
17. With the fall arrest block above the user, the clear height below the user must be 2.4m
( ).
11
18. The IKAR fall arrest block with recovery mechanism can be used in a temperature range
from -40 °C to +50° C in accordance with EN 360
19. The rated load is 136 kg
20. Fall arrest blocks with recovery mechanisms must be protected from the effects of welding
flames and sparks, fire, acids, lyes, solvents and similar agents.
21. No modifications may be made on the device.
22. Note: Fall arrest blocks with recovery mechanism may only be used by persons who are
appropriately trained or otherwise skilled. Users must be free from health impairments
(alcohol, drug, medication or cardiovascular problems)
23. The service life of the fall arrest block with recovery mechanism must be determined in the
yearly inspection; it is approx. 10 years depending on load stress.After every use of the
fall arrest block, the device must be inspected by an expert trained by the
manufacturer.
24. After every use of the fall arrest block, the device must be inspected by an expert trained
by the manufacturer.
25. When the HRA fall arrest block is used, it must be ensured that the loaded lifeline does
not pass over edges.

Service and maintenance

1. The lifeline shall only retract under load. On no account may the lifeline be fully pulled
out and released because the karabiner hook jolting against the device may cause the
retraction spring to break
2. For devices that are constantly exposed to the weather, it is recommended to greas the
steel rope with acid-free oils or Vaseline at regular intervals.
3. Retractable connection elements made of para-aramid fibres (textile) may only be cleaned
with warm water or neutral cleaning agents. Never use thinner or similar. Any residues
from the cleaning agent must be rinsed out completely with clean water.
4. IKAR fall arrest blocks with recovery mechanism should be stored in dry, dust- and oilfree
condition in a suitable container.
5. Components which have become wet during cleaning or use may only be dried natrally,
not near a fire or similar heat sources.
6. Before using disinfectants, you have to contact the manufacturer due to the complex legal
product classifications based on the specific applications and constituents.

Accessories

Please note: In order to prevent a negative impact on the safe function of the fall arresting de-
vices, it is only permitted to use accessories approved by the manufacturer (e.g. rescue clamps
to DIN 19428:2018, protective covers, etc.). The manufacturer is not liable for any accidents
involving the life and limb of the user if using non-approved accessories.
)
. This must be documented in the inspection log book supplied with
( )
.
13
( )
.
14
ENGLISH
( )
.
9
( )
.
12
13
10
11
12
13
14