4.8.1
Table height adjustment
Release the clamping screw
on the drilling table.
Turn the drilling table to the
required height by means of
the crank handle.
Retighten the clamping
screws.
4.9
Disassembly, assembly of drill chucks and drill bits
4.9.1
Fitting the drill chuck
The quick-action drill chuck
is secured through a form-
fit union (driver) against
twisting in the drilling spin-
dle.
A
friction-locking
holds
and
centers
quick-action
drill
with the taper mandrel in
the drilling spindle.
Check and, if necessary, clean the conical seat in the drilling spindle and at the taper man-
drel of the tool or the quick-action drill chuck.
Press the taper mandrel into the drilling spindle.
Operation
Version 1.1.8 dated 2018-9-13
Clamping lever
Crank handle
Img.4-6:
Drill sleeve
union
the
chuck
Driver
Taper mandrel
Img.4-7:
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Table height adjustment
Taper mandrel
®
B16H | B16HV
GB
Page 79