Inhaltsverzeichnis
Werbung
4.11
Disassembly, assembly of drill chucks and drill bits
CAUTION!
Preventive safety measure. Pull the mains plug of the drilling machine.
ATTENTION!
The tool and/or the drill chuck will fall down. Hold the tool or the drill chuck while drifting
it out.
Taper mandrels can be disassembled with an common drill drift.
Disconnect the machine from the
electrical supply. Pull out the mains
plug.
Turn the drilling spindle until the
openings of the sleeve and of the
drilling spindle are superimposed.
Hold the tool with your hand.
Loosen the tool with the help of a
drill drift (15).
Hold the tool by hand and remove it
from the conical seat.
4.12
Quick action - drill chuck
In order to clamp a drill bit, hold the
upper part of the quick-action drill chuck
and turn the lower part.
CAUTION!
Make sure that the clamped tool is firmly and correctly fitted.
Operation
Version 1.0.3 - 2020-07-14
Img. 4-7:
Tool removal
Drill sleeve
Drill drift
Upper part of quick-
action drill chuck
Bottom part of
quick-action drill
chuck
Img. 4-8:
Translation of original instruction
15
Quick action - drill chuck
D17 Pro│D23 Pro│D26 Pro│D33 Pro
EN
97
Werbung
Inhaltsverzeichnis
