Inhaltsverzeichnis
Werbung
4.8.2 Speed table - DH 26 GT ǀ DH 28 GS
Img.4-5:
DH26GT ~50Hz
Img.4-6:
DH 28GS ~50Hz
ATTENTION!
Wait until the drilling spindle has come to a complete halt before changing the speed
with the gear selector switch.
A change of the gear ratio during operation can lead to the destruction of the gearbox.
4.9
Disassembly, assembly of drill chucks and drill bits DH26GT ǀ DH28GS
4.9.1
Use of the quick-action drill chuck
The drill chuck consists of two parts (1 and 2).
Hold the upper part (No.1) of the drill chuck. With the bottom part of the drill chuck (No. 2) it
is possible to tighten or loosen the jaws of the quick-action drill chuck.
Turn the tool (drill) firmly.
Upper part (No. 1)
quick-action drill
chuck
Bottom part (No. 2)
quick-action drill
chuck
Tool (drill)
CAUTION!
Make sure that the clamped tool is firmly and correctly fitted.
EN
DH26GT | DH28GS
102
Img.4-7: Quick-action drill chuck
Translation of original instruction
Version 1.2.9 - 2021-09-28
Werbung
Inhaltsverzeichnis
