Transportation To The Installation Site; Installation And Assembly; Requirements Regarding The Installation Site; Assembly - Optimum OPTIdrill DH 28BV Betriebsanleitung

3.2

Transportation to the installation site

ATTENTION!
The drilling machine is lifted and transported at the drilling head or at the load
suspension points of the packaging using a suitable hoisting device.
Make sure that the housing of the pulleys is not getting damaged when suspending the
load without packaging. Use squared timber in order to keep the lifting slings away from
the housing of the pulleys.
ATTENTION!
Make sure that the load suspension point is balanced (centre of gravity).

Disassemble the fixing screws which are used to fix the machine in the
packaging.

Lift the drilling machine carefully from the pallet of the packaging by means of a crane and a
forklift truck.
3.3

Installation and assembly

3.3.1

Requirements regarding the installation site

Organize the working area around the drilling machine according to the local safety regulations.
INFORMATION
In order to attain good functionality and a high processing accuracy as well as a long service life
of the machine, the place of installation should fulfil certain criteria.
Please observe the following points:
The device must only be installed and operated in a dry and well-ventilated place.

Avoid places nearby machines generating chips or dust.

The installation site must be free from vibrations also at a distance of presses, planing

machines, etc.
The substructure must be suitable for machines. Also make sure that the floor has suffi-

cient load bearing capacity and is level.
The ground must be prepared in a way that potential coolants cannot penetrate the floor.

Any parts sticking out such as stops, handles, etc. have to be secured by measures taken

by the customer if necessary in order to avoid endangering persons.
Provide sufficient space for the personnel preparing and operating the machine and trans-

porting the material.
Also make sure the machine is accessible for setting and maintenance works.

Provide for sufficient backlight (Minimum value: 500 lux, measured at the tool tip). At lower

illumination intensities, additional illumination has to be ensured e.g. by means of a sepa-
rate workplace lamp.
INFORMATION
The main switch of the drilling-milling machine must be freely accessible.
3.3.2

Assembly

WARNING!
Danger of crushing and overturning.
The drilling machine must be installed by at least 2 people.
Version 1.1.4 - 2022-09-14
DH24BV | DH28BV | DH34BV | DH40BV
Originalbetriebsanleitung
GB
87