General information
Compliance with and implementation of all relevant directives and safety measures for
the respective field of application is the sole responsibility of the operator.
All risks resulting from improper use are borne solely by the operator.
The device may only be operated by authorized and instructed personnel. Training and
qualification of the operating personnel as well as ensuring that the device is handled
responsibly are the sole responsibility of the operator!
Transportation
During transportation, avoid severe shocks and mechanical stresses that can cause
damage to the device.
Keep the original packaging in a dry and protected place for later use.
Storage
Always store the device in its original packaging. To protect against damage and
excessive material aging, store the device in an environment that is as dry, tempera-
ture-stable and dust-free as possible.
Acclimatization
After each transportation and after storage under critical climatic conditions (e.g. high
temperature difference between inside and outside), allow the device to acclimatize at
room temperature for at least two hours to prevent possible damage due to condensa-
tion before commissioning it in the place of use. If necessary, extend the acclimatization
phase if the temperature differences are very high.
Make all supply connections (power supply, tubing) only after the device has been
acclimatized!
Permissible ambient conditions
The device is designed for indoor use only. Permissible ambient conditions for
operation:
•
5 °C – 31 °C at up to 80 % rel. humidity
•
32 °C – 40 °C at up to 50 % rel. humidity (decreasing linearly)
•
Installation altitude: 2,000 m asl
When used in corrosive atmospheres, the service life of the device may be reduced
depending on the concentration, duration and frequency of exposure.
The device IS NOT suitable for outdoor use!
The device IS NOT suitable for use in potentially explosive areas!
86