Initial Filling Of The Evaporation Flask - Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung

Commissioning

Initial filling of the evaporation flask

Complete the following steps for filling the evaporation flask to ensure continuous
supply of the educt during operation:
➜
Turn on the rotary evaporator and wait for the software to initialize (start screen
appears on the control panel).
➜ Switch on the heating bath heater and the recirculation chiller.
➜
Turn on Distimatic Pro and wait for the software to initialize (start screen appears
on the control panel).
➜ Start any given process by touching the
panel of the Distimatic Pro.
➜ Open the inlet valve on the educt sensor vessel.
➜
Close the inlet valve when the displayed level is reached
Start process
button on the control
.
109