Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung Seite 147

Operation
Procedure
Start process
➜
Touch the
– The vacuum pump is switched on, the pressure in the evaporation flask is
lowered to process pressure.
– In the footer, the
Fill educt
➜
Touch the
flask.
By briefly tapping the
injected into the evaporation flask.
Touch the
(observe button progress) to fill the evaporation flask continuously.
The filling has to be stopped manually!
Fill educt
➜
Touch the
Stop process
➜ Touch the
When the process is ended, the
appears on the control panel.
Drain distillate
➜
Touch the
approx. 30 s).
Drain distillate
➜ Touch the
The evaporation flask must be drained by hand.
Please observe the relevant information and instructions in the
operating instructions for the rotary evaporator!
button.
Fill educt Stop process
and
button to start the automatic filling of the evaporation
Fill educt
Fill educt
button for approximately 2 seconds
button again to stop filling.
button to stop the process (end process).
 button. The distillate is drained (default:
 button. Drainage of the distillate is stopped.
147
buttons are displayed
button, a small amount can be
Drain distillate
button