K) Adjusting Output Activation Time; L) Deleting The Transponder/User Code - Sygonix 1717531 Bedienungsanleitung

k) Adjusting output activation time

The potential-free changeover contact of the code lock will be enabled if (depending on the
selected operating mode) a correct user code is entered and/or a tuned in transponder card is
held in front of the code lock.
The changeover contact activation time is adjustable.
Proceed as follows:
• Enable the programming mode; see chapter 9. a).
• Enter . The control LED will flash yellow.
• Enter the desired changeover contact activation time in seconds (an entry of
seconds is possible, where the setting
time of approx. < 0.5 seconds).
Example:
Example:
• The code lock will emit a long sound signal and the control LED will glow yellow steadily.
• Press the button to exit programming mode. The control LED will glow red steadily.

l) Deleting the transponder/user code

• Enable the programming mode; see chapter 9. a).
• Enter the memory number that you want to delete (
• The colour of the flashing control LED indicates whether the memory is full:
- LED flashes red: Memory is full
- LED flashes green: Memory is empty
• If you want to cancel the deletion process, briefly press the
• To clear an occupied memory, press the
to indicate that the memory is now cleared and empty. Afterwards, press the
control LED will now glow yellow steadily.
You can now clear another memory, if desired. Proceed by entering the memory num-
ber that you want to delete as described above.
• Press the button to exit programming mode. The control LED will glow red steadily.
= 5 seconds
= 10 seconds
stands for the technically shortest possible
.....
button.
button twice. The control LED will flash green
.....
).
button. The
47