Programming; Enabling/Disabling Programming Mode - Sygonix Touch S Bedienungsanleitung

8. Programming

Important!
We recommend that you note all codes and settings. You will thus be able to refer to
them over time and adapt them to new requirements.
The code lock can be reset to factory defaults, in which case all settings are lost
(stored transponders/user codes are retained and may have to be deleted separately).
a) Enabling/disabling programming mode
• To enable the programming mode, enter the master code twice in a row (factory setting =
1234). Each button press is confirmed with a brief audible beep.
Default master code:
A transponder can be saved as a "master transponder" (see section 8. s). Other than
entering the master code twice using the keypad, you can also start the programming
mode by holding the master transponder in front of the RFID sensor (this option is not
possible when the master code needs to be changed, which means that the keypad is
the only option for security reasons).
• The programming mode is enabled when the LED lights up yellow and the code lock emits
a long beep.
• This mode allows pairing transponders, saving user codes or making various settings.
• To exit the programming mode, press the
mode.
When no button is pressed within 30 seconds after calling up the programming mode,
it is exited automatically for security reasons and the code lock goes back to standby
mode. Previously programmed settings will be accepted.
button. The code lock goes back to standby
51