Delivery And Installation Instructions; Delivery Check; Space Requirement; Connecting To Supply Lines In The Laboratory - Sartorius Stedim Biotech BIOSTAT RM 20 basic Bedienungsanleitung

2. Delivery and Installation
Instructions

2.1 Delivery Check

2.2 Space Requirement

2.3 Connecting to Supply Lines
in the Laboratory

2.3.1 Work Area Preparation

2.3.2 Power Connection

2. Delivery and Installation Instructions

The BIOSTAT RM 20 | 50 basic is delivered after conducting extensive function tests.
®
Please proceed as follows if there is transport damage or any device defects appear
after installation:
1. Check the order confirmation and shipping documents for correctness.
2. Check all system components for damage.
3. Inform Sartorius Stedim Biotech Customer Service regarding which parts are
defective or missing.
4. Check the suitability of all units and individual parts before the first cultivation
process.
5. Document the defects and malfunctions carefully and provide this information to
Sartorius Stedim Biotech Customer Service.
The following table contains information about the space requirement for the
BIOSTAT ® RM 20 | 50 basic:
Bioreactor configuration:
BIOSTAT ® RM 20 basic
BIOSTAT ® RM 50 basic
Make sure that the setup location has the required dimensions and is level
This is the only way to ensure problem-free operation of the system.
The connections required are included in the scope of delivery. Additional
connections are available for special requirements. Please contact Sartorius Stedim
Biotech Customer Service for further information.
1. Make sure that there is enough work area available for the setup and installation
of the bioreactor:
y Placement of the BIOSTAT
y Connection to laboratory lines
y Placement of the CultiBag RM
y Additional peripheral devices
2. Check the power connections:
y The main connections in the laboratory | work area must conform to the
specifications of the bioreactor.
Danger of electrical damage to device!
The power supply must correspond to the requirements of the device.
Voltage fluctuations may not occur. Make sure that the power connection is
equipped with a ground lead.
Make sure that a correct and disruption-free power supply is guaranteed.
Only the named components may be connected to each other. Never connect
to the power supply when the device is switched ON.
Check the labels on the devices to ensure that the correct power connections were
delivered and that the power cables required for the supply connections in the
laboratory are equipped with the proper connections. Please contact Sartorius Stedim
Biotech Customer Service, if the devices are equipped with incorrect plugs and cables.
Space requirement W + H + D (mm):
765 + 600 + 580
1085 + 600 + 580
® RM 20 | 50 basic
Delivery and Installation Instructions 19