Troubleshooting; Defaults; Procedure For Setting The Defaults - Medtronic ACT Plus Benutzerhandbuch

ACT_A.fm 6/23/04 1:23 pm
UC200304151c ML
5.5" x 7.75" (139.7 mm x 196.85 mm)
Scan the "NOTIS Editing Enable" bar code. To remove the Start/Stop characters
from the Codabar barcodes.

Troubleshooting

Nothing happens when you follow
the operating instructions.
The laser comes on, but the symbol does
not decode.
The symbol is decoded, but not transmitted
to the host.

Defaults

If the bar code scanner does not read the bar code on the ACT Plus™ disposable
packaging, reset the defaults before calling Medtronic Instrument Service. To reset
the defaults, follow this procedure, and try to rescan the packaging.

Procedure for setting the defaults:

1. To ensure that the scanner is reset, first scan the Set All Defaults bar code.
54 English
86702-001 Rev 1.0
Figure 17. Enable NOTIS Editing
Interface/power cables are loose. Check for
loose cable connections.
The scanner is not programmed for the
correct bar code type. Be sure the scanner
is programmed to read the type of bar code
you are scanning.
The bar code symbol is unreadable. Check
the symbol to make sure it is not defaced.
Try scanning test symbols of the same bar
code type.
The distance between the scanner and bar
code is incorrect. Move the scanner closer
to the bar code.
The scanner is not programmed for the
correct bar code type. Be sure the scanner
is programmed to read the type of bar code
being scanned.
Figure 18. Set All Defaults bar code
Medtronic Confidential
ACT Plus™ Operator's Manual
CS010