Rear Panel Components; Instrument Bottom; Optional Bar Code Scanner - Medtronic ACT Plus Benutzerhandbuch

ACT_CH.fm 6/23/04 1:23 pm
UC200304151c ML
5.5" x 7.75" (139.7 mm x 196.85 mm)

Rear Panel Components

1. Handle.
2. The Fuse Holder is located in the Power Inlet Module. See Maintenance on
page 40 for fuse replacement.
3. The Main Power Switch is a rocker-type switch: "|" indicates ON and "O"
indicates OFF. It is located in the Power Inlet Module.
4. The Power Inlet Module is used to connect the power cord to the ACT Plus™
instrument.
5. The Equal Potential Terminal is used to connect the ground of the ACT
Plus™ instrument to other instruments that may be used in a clinical setting.
6. The Serial Port (RS-232) is a female DB-9 connector (see Specifications on
page 10 for detailed specifications).
7. The USB Port is for future applications; it is not supported at this time.
8. The Bar Code Scanner Port is the connection for the optional bar code
scanner (see Specifications on page 10 detailed specifications).
9. The Floppy Drive is used to transfer and store patient and QC test history
data.

Instrument Bottom

The Serial Number Label, which contains the serial number, date of manufacture,
and safety agency approvals, is located on the bottom of the ACT Plus™
instrument.

Optional Bar Code Scanner

See Optional Bar Code Scanner on page 51 for additional information.
ACT Plus™ Operator's Manual
86702-001 Rev 1.0
Medtronic Confidential
CS010
English 17