Switching From A Mymode Back To Basic Mode; Changing Prosthesis Settings - Ottobock 1B1-2 Gebrauchsanweisung

4) Remove the load from the prosthetic leg.
→ The mode has been changed.
5) Within 2 seconds, lower the prosthetic leg and assume the required position of the ankle
angle.
→ At the end of this time, a signal will occur to indicate the locking of the ankle joint.

8.3.4 Switching from a MyMode back to basic mode

INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 70).
Information on switching
• Regardless of the configuration of additional MyModes in the adjustment software, it is always
possible to switch back to basic mode (mode 1) with a motion pattern.
• It is always possible to switch back to basic mode (mode 1) by connecting/disconnecting the
battery charger.
• Before further activities, always check whether the selected mode corresponds to the
required motion type.
Switching process
1) Hold the prosthetic leg under the body.
2) Using the heel of the prosthetic foot, knock on a solid obstacle behind you at least 3 times but
no more than 5 times.
→ A beep and vibration signal will occur to confirm that the motion pattern has been recog­
nised.
3) Lean the prosthetic foot slightly to the back and place weight on the forefoot.
INFORMATION: If the prosthetic foot is strongly dorsiflexed, weight can be placed on
the heel.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched
over to basic mode.
INFORMATION: If this confirmation signal does not occur, weight was not placed
on the prosthetic foot correctly or not for enough time. Repeat the process to cor­
rectly switch to the required mode.
4) Remove the load from the prosthetic leg.
→ The mode has been changed.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.

8.4 Changing prosthesis settings

Once an active connection to a component has been established, the settings of the respective
active mode can be changed using the Cockpit app.
INFORMATION
Bluetooth on the prosthesis must be switched on to change the prosthesis settings.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period.
Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the Cockpit app to make sure the
correct component has been selected. Otherwise parameters could be changed for the
wrong component.
70