Switching From A Mymode Back To Basic Mode; Changing Prosthesis Settings - Ottobock C-Leg 3C88-3 Gebrauchsanweisung

8.2.3 Switching from a MyMode back to basic mode

Information on switching
• Regardless of the configuration of additional MyModes in the adjustment software, it is always
possible to switch back to basic mode (mode 1) with a motion pattern.
• It is always possible to switch back to basic mode (mode 1) by connecting/disconnecting the
battery charger.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Position the prosthetic leg back slightly (lunge position) and bounce on the forefoot while
maintaining constant contact with the floor.
Then keep the prosthetic leg still in this position (lunge position) for about 1 second without
lifting the leg. Taking the weight off is no longer necessary.
Switching process
1) Position the prosthetic leg back slightly (lunge position).
2) While maintaining constant contact with the floor, bounce on the forefoot at least 3 times but
not more than 5 times.
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second
without lifting the leg. Taking the weight off is no longer necessary.
→ A beep signal will sound to confirm that the motion pattern has been recognised.
INFORMATION: If this beep signal does not sound, the requirements were not
observed when bouncing the foot.
4) Move the prosthetic leg in next to the contralateral leg, set it down and keep it still for approx.
1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched over
to basic mode.
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis
was not correctly repositioned and kept still. Repeat the process to correctly switch to
the required mode.

8.3 Changing prosthesis settings

Once an active connection to a prosthesis has been established, the settings of the mode cur­
rently active can be changed using the cockpit app or the remote control (optional accessory).
INFORMATION
Bluetooth on the prosthesis must be switched on to change the prosthesis settings.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period.
Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the cockpit app or the display of
the remote control (optional accessory) to make sure the correct prosthesis has been selec­
ted. Otherwise, parameters could be changed for the wrong prosthesis.
• It is not possible to change prosthesis settings nor to switch to a different mode while the
prosthesis battery is being charged. Only the status of the prosthesis can be called up.
Instead of the
pit app.
58 | Ottobock
symbol, the symbol appears in the bottom row of the screen in the cock­