Switching Mymodes With The Cockpit App; Switching Mymodes Using Motion Patterns - Ottobock 1B1-2 Gebrauchsanweisung

The MyModes are intended for specific motion patterns or postures (e.g. golfing, ...). Settings
can be adjusted using the Cockpit app (see Page 72).

8.3.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 72).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 70).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
Product
1. Basic Mode 2. Golf
1
2
3
100% 1. Basic Mode

8.3.2 Switching MyModes using motion patterns

INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 70).
Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
68
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
lower edge of the screen (3).