Signals For Operating States; Warnings/Error Signals - Ottobock 1B1-2 Gebrauchsanweisung

14.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1x short
1x short
Mode switching
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 70).
Beep signal Vibration
signal
1 x short 1 x short
1 x short 1 x short
1 x short 1 x short
2 x short 2 x short
3 x short 3 x short

14.2.2 Warnings/error signals

Error during use
Beep signal
–
–
Vibration signal
3x short
1x before beep signal Battery charger disconnected after start of char­
Additional action per­
formed
Mode switching using the
Cockpit app
Tapping with heel to switch
modes or
swing sideways three times
to set heel height
Weight placed on prosthetic
leg and leg kept still for
1 second to switch mode or
feet placed on same level
and weight distributed
evenly on both feet to set
heel height
Weight placed on prosthetic
leg and leg kept still for 1
second
Weight placed on prosthetic
leg and leg kept still for 1
second
Vibration signal
1 x long at interval of
approx. 5 seconds
3 x long
Event
Battery charger is connected or
battery charger already disconnected prior to
start of charging mode
Charging mode started (3 sec. after connection
of battery charger)
ging mode
Event
Mode switching is performed
using the Cockpit app
Motion pattern recognised
Switching to basic mode
(mode 1) carried out.
Switching to MyMode 1 (mode 2)
carried out.
Switching to MyMode 2 (mode 3)
carried out.
Event
Overheated hydraulic
unit
Battery charge level
under 25%
Required action
Reduce activity.
Charge battery soon.
79