Switching The Product On And Off - Ottobock AxonHook 8E600 Serie Gebrauchsanweisung

7.2 Settings
Adjustments to the product can be made via Bluetooth data transmission using the 560X500=*
AxonSoft software. For this purpose, a wireless connection must be established between the
13E500 AxonMaster and the PC with the help of the 60X5 BionicLink PC.
For further information, see the instructions for use provided with the 13E500 AxonMaster and the
560X500=* AxonSoft software.
8 Use
8.1 Changing the Axon-Bus gripping component
Attaching the Axon-Bus gripping component to the socket
1) Slide the terminal device on to the socket (rotation anchored in the socket) until it locks in
place audibly.
2) Verify proper attachment by pulling on the terminal device.
Separating the Axon-Bus gripping component from the socket

8.2 Switching the product on and off

CAUTION
Storage of the product in the closed state
Injury due to faulty control or malfunction of the product as a result of damage to the sensors
and mechanism.
► Store the product only in the neutral position or in the open state.
22
1) To switch off the Axon-Bus prosthetic system, press the charging
receptacle button and hold for more than one second.
2) Press both unlock buttons on the flexion wrist unit.
INFORMATION: For safety reasons the Axon-Bus gripping
component cannot be removed if only one unlock button is
pressed.
3) Separate the Axon-Bus gripping component from the socket.
The product is switched on and off by pressing the button in the char­
ging receptacle on the outside of the socket.