Cockpit App - Ottobock 1B1-2 Gebrauchsanweisung

Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 70).
Display of the current charge level using the cockpit app:
Once the Cockpit app has been started, the current charge level is displayed in the bottom line of
the screen:

7 Cockpit app

INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more
information, please visit the website: http://www.ottobock.com/cockpitapp. To download the
Cockpit app, the QR code on the supplied Bluetooth PIN card can be read with the mobile
device (requirement: QR code reader and camera).
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold the prosthesis still and wait for beep signals.
Prosthetic foot with knee joint:
The beep signal for the knee joint sounds after approx.
2 seconds.
The beep signal for the prosthetic foot sounds after approx.
4 seconds.
Prosthetic foot without knee joint:
The beep signal for the prosthetic foot sounds after approx.
2 seconds.
Vibration signal
1.
component
The cockpit app enables switching from basic mode into the pre-configured
MyModes. In addition, information about the product (step counter, battery
charge level, etc.) can be called up.
The behaviour of the product can be changed to a certain extent on a day-to-
day basis using the app (e.g. while becoming accustomed to the product). At
the next appointment, the prosthetist can trace the changes using the adjust­
ment software.
–
–
–
–
3x long
5x long
38% – Charge level of battery for currently connected
Battery charge level
More than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
Less than 20%
59