Maintenance And Care; Maintenance; Mechanical - probst HVZ-GENIUS-II Betriebsanleitung

Maintenance and care

7 Maintenance and care
7.1

Maintenance

To ensure the correct function, safety and service life of the device the following points must be executed
in the maintenance interval.
Used only original spare parts, otherwise the warranty expires.
All operations may only be made in unpressurised, electro less and closed state of the device!
For all operations you have to make sure, that the device will not close unintended.
Danger of injury!!!
7.1.1

Mechanical

SERVICE INTERVAL
First inspection after
25 operating hours
All 50 operating hours
Minimum 1x per year
(at rough conditions shorten the
interval)
Grease nipples
Grease (1x per week) all 5 grease nipples at the
side clamping at left and right side of the device
with a grease pistol
→ see arrows .
5140.0042
Maintenance work
•
Control and tighten all screws and connections.
(The implementation is only allowed by an expert).
•
Tighten all screws and connections (take care that the tightening torques according to
the property class of the screws are observed).
•
Check all existing safety elements (such as linchpins) for perfect function and replace
defective safety elements. → 1)
•
Check all joints, bolts, guidance's and gears for correct function, if necessary adjust or
replace it.
•
Check all grippers (if available) for signs of wear.
•
Grease all slidings (if available) when the device is in opened position with a spatula.
•
Grease all grease nipples (if available) with a grease gun.
•
Check of all the suspension parts, bolts and straps. Check for corrosion and safety by an
expert.
1)
Grease (1x per week) the grease nipples at the boom
cylinder (see ) at left and right side of the device
with a grease pistol.
V1
41 / 45
GB