Parameter Reset To Factory Setting - Siemens simovert masterdrives Betriebsanleitung

Parameterization
8.6
Unit carries out parameter
reset and then leaves the
"Fixed settings" menu.
8-26
Downloaded from www.Manualslib.com

Parameter reset to factory setting

The factory setting is the defined initial state of all parameters of a unit.
The units are delivered with this setting.
You can restore this initial state at any time by resetting the parameters
to the factory setting, thus canceling all parameter changes made since
the unit was delivered.
Grant parameter access
P053 = 6
6: Parameter changes permitted via PMU and serial interface
SCom1 (OP1S and PC)
P060 = 2 Select "Fixed settings" menu
Select desired factory setting
P366 = ?
0: Standard
Note:
Start parameter reset
P970 = 0
0: Parameter reset
1: No parameter change
Fig. 8-17
manuals search engine
This parameter was correctly set prior to delivery of
the unit and only needs to be changed in exceptional
cases.
Sequence for parameter reset to factory setting
Operating Instructions
06.2006
6SE7087-6KN50 Siemens AG
SIMOVERT MASTERDRIVES