Siemens simovert masterdrives Betriebsanleitung Seite 192

First Start-up
If necessary, carry out
parameter modules
supply or line voltage
4-2
Downloaded from www.Manualslib.com
If the PMU does not show status °005 after completion
of the unit initialization, or if the unit has already been
parameter reset to
parameterized before, you should carry out a parameter
factory setting
reset to factory setting.
Parameterizing by
download or with AAA
De-energize 24 V
After checking the unit and the cabling once more, power
up the line voltage or DC bus voltage and perform a
function test according to your parameterization.
WARNING
Function test
Further start-up and parameterization according to
your specific requirements
manuals search engine
It must be ensured that no danger for
persons and equipment can occur by
energizing the power and the unit. It is
recommended not to couple the driven
machine until the function test has been
successfully completed.
Operating Instructions
06.2006
See section
"Parameterization"
See section
"Parameterization"
siehe
"Anschließen"
und "EMV-
gerechter
Aufbau"
siehe "Ans
6SE7087-6KN50 Siemens AG
SIMOVERT MASTERDRIVES