Siemens simovert masterdrives Betriebsanleitung Seite 241

06.2006
NOTE
Siemens AG
SIMOVERT MASTERDRIVES
Downloaded from www.Manualslib.com
Some parameters may also be displayed without a parameter number,
e.g. during quick parameterization or if "Fixed setting" is selected. In
this case, parameterization is carried out via various sub-menus.
Example of how to proceed for a parameter reset.
0.0 A 0 V
# 0.00 min-1
* 0.00 min-1
Selection of fixed setting
P
Fixed Setting
*Select FactSet
FactSet.
Selection of factory setting
P
Factory Setting
#FactSet.
*No FactSet
busy............
Start of factory setting
It is not possible to start the parameter reset in the "Run" status.
6SE7087-6KN50
Operating Instructions
manuals search engine
P P
00 MotionControl Menu Selection
*Menu selection *User Param.
OP: Upread Param Menu..
Ready OP: Download Fixed Set...
∇
P
Fixed Setting Factory Setting
*Select FactSet FactSet.
#FactSet. *No FactSet
wait
Menu Selection
*User Param..
Param. Menu..
FixedSet...
Parameterization
2 x
∇
Menu Selection
*User Param.
Param Menu..
#Fixed Set...
Factory Setting
#FactSet.
*No FactSet
8-13