Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 234

CONTINUITY INSPECTION
Remove the starter relay switch.
Connect an ohmmeter to the switch large terminals.
Connect a fully charged 1 2 V battery positive wire to the start-
er relay switch Yellow/Red wire terminal, and the battery neg-
ative wire to the Green/Red wire terminal.
There should be continuity while the battery is connected to
the terminals, and no continuity when the battery is discon-
nected.
CLUTCH DIODE
REMOVAL
Remove the rear cowling (page 13-25).
Remove the clutch diode from the wire harness.
INSPECTION
Check for continuity with an ohmmeter.
Connect the positive probe to the
(+)
terminal and the negative
probe to the (-) terminal of the diode.
There should be continuity, then reverse the probes, there
should be no continuity.
NOTE
The test results shown above are for a positive ground ohm-
meter and the opposite results will be obtained when a neg-
ative ground ohmmeter is used.
ELECTRIC STARTER
(1 )
STARTER
RELAY SWITCH
(1) CLUTCH DIODE
17-7