Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 173

REAR WHEEL/SUSPENSION
SPROCKET
REMOVAL
Turn the eccentric bearing carrier to loose the drive chain, then
remove the chain from the sprocket.
Remove the sprocket mounting bolts and the sprocket.
INSTALLATION
Install the sprocket by using the bolts and nuts.
TORQUE: 43 N·m (4.3 kg-m, 31 ft-Ibl
Reinstall the drive chain and adjust the slack (page 3-12).
ECCENTRIC BEARING CARRIER
REMOVAL
Remove the rear wheel (page 13-3).
Loosen the eccentric bearing carrier pinch bolt and turn the
carrier to loosen the drive chain.
\\
(1) REAR WHEEL '.
(1) SPROCKET
Tap the axle with a soft hammer until the splines clear the
driven flange cover.
Remove the axle to the left side.
13-6