Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 180

REAR WHEEL/SUSPENSION
(1) SPINDLE
(4) SPLINES
(2) ECCENTRIC BEARING CARRIER
(31 DRIVEN FLANGEI
SPROCKET
"
Install the drive chain on the sprocket and position the flange
against the eccentric bearing carrier.
Insert the spindle through the bearing carrier and driven flange.
Engage the driven flange and the spindle, making sure the
splines are correctly mated.
CAUTION
• Use care not to damage the pads when installing the caliper.
Install over the brake caliper onto the brake disc.
Install and tighten the mounting bolts.
TORQUE: 27 N'm (2.7 kg-m. 20 ft-Ibl
(1) CALIPER MOUNTING BOLT
~
Install the rear axle from the left side.
Install the side collar onto the driven flange.
Install the lock washer onto the spindle as shown.
.
.
~"'NS'DE
Install the eccentric bearing carrier lock nut and stake it.
TORQUE: 165 N'm (16.5 kg-m. 120 ft-Ib)
13-13