Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 140

CONNECTING ROD ASSEMBLY
Install the bearing inserts on the rods and caps.
NOTE
Align the boss on the bearing with the groove in the rod or
cap.
Apply molybdenum disulfide grease to the bearing.
Install the connecting rods and caps on the crankpin. Be sure
each part is installed in its original position, as noted during re-
moval.
Tighten the bearing cap nuts.
NOTE
Align the 1.0. code on the cap and rod.
Tighten the nuts in two or more steps. After tightening,
check that the rods move freely without binding.
TORQUE: 34 N'm (3.4 kg-m. 25 ft-Ibl
Install the crankshaft in the left crankcase.
Install the dowel pins and assemble the crankcase (page 11-
16).
TRANSM ISSION
REMOVAL
Remove the mainshaft. countershaft, shift fork shaft and shift
drum as an assembly.
Separate the shift forks/shaft, mainshaft and countershaft as-
semblies from each other.
DISASSEMBLY/INSPECTION
Bend down the lock washer tabs and remove the bolt and lock
washer from the center shift fork.
Remove the shift fork shaft.
Disassemble the mainshaft and countershaft.
CRANKSHAFT/TRANSMISSION
(1) Apply molybdenum disulfide grease
(1) TRANSMISSION ASSEMB\
(1) LOCK WASHER
11-9