Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 188

REAR WHEEl/SUSPENSION
Install the snap ring into the groove in the swingarm.
Apply clean grease to the dust seal lips and install the dust
seals in the swingarm pivots.
(2) SWINGARM
(1) SNAP RING
ASSEMBLY
(2) BRAKE HOSE CLAMP
(3) SHOCK ABSORBER
DRAIN TUBE CLAMP
(1) DRIVE CHAIN SLIDER
TORQUE:
35
N'm
13.5
kg-m.
25
ft-Ibl
Install the brake torque rod with a new cotter pin.
Install the following components:
- drive chain slider
- driven sprocket guard plate
- brake disc guard plate
- shock absorber drain tube clamp
- brake hose clamp
(6) DRIVEN SPROCKET
GUARD PLATE
(5) BRAKE DISC
GUARD PLATE
INSTALLATION
Install the pivot collars and bushing in the swingarm.
Loosely install the pivot adjusting bolt then install the
swingarm to the frame.
Insert the pivot bolt through the adjusting bolt fully.
13-22