Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 139

CRANKSHAFT/TRANSMISSION
MAIN BEARING REPLACEMENT
Press the main bearing out of the crankcase using a hydraulic
press and special tools.
NOTE
• Always use a press to remove the main bearing.
TOOLS:
Driver 07749-0010000
Main bearing remover attachment 07HMF-MM90400
Mark a vertical line below each side of the bearing tab.
Apply molybdenum disulfide grease to the outer surface of the
main bearing.
Align the marks on the bearing with the groove in the bearing
hole, and press the main bearing into the crankcase.
(2) MARKS
CAUTION
(3) GROOVE
• Be careful not to damage the bearings.
CONNECTING ROD SELECTION
A letter stamped on the connecting rod is the code for the
rod's weight.
When replacing the connectring rod, select the new rod by
cross-matching the front and rear cylinder connecting rod
weights using the selection table below.
(1) DRIVER
(2) ATTACHMENT
07749-0010000
07HMF - MM90400
TOOLS:
Driver
Main bearing driver attachment
NOTE
The "0" mark in the table indicates that the matching is
possible in the crossed codes.
SELECTION TABLE
1\
Front rod code
A
B C D
Rear rod code \
A 0 0
------
----------
B 0
0 0
----------
C
--------
0
0 0
D
--------
--------
0 0
m~'9
1
(1) WEIGHT CODE LETTER
11-8