Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 217

(1) CHRISTIE BATTERY
CHARGER
BATIERY/CHARGING SYSTEM
-'-------------
• Keep flames and sparks away from a charging battery.
Turn power ON/OFF at the charger, not at the battery termi-
nals.
CAUTION
Quick-charging should only be done in an emergency; slow
charging is preferred.
For battery charging, do not exceed the charging current and
time specified on the battery. Using excessive current or extend-
ing the charging time may damage the battery.
CHARGING WITH CHRISTIE BATTERY CHARGER
NOTE
Use the CHRISTIE Battery Charger (MC 1012/2) to charge
the battery.
Before operating the charger:
Be sure the area around the charger is well ventilated and
clear of flammable materials, heat, humidity, water and
dust.
Clean the battery terminals and position the battery as far
away from the charger as the leads will permit. Do not place
the battery below the charger gases from the battery may
corrode and damage the charger.
Do not place the battery on top of the charger. Be sure the
air vents are not blocked.
-'-------------
During operation, the charger will grenerate heat. To avoid
causing a fire, always clear the work area offlammable materi-
als such as gasoline, brake fluid, electrolyte, or cloth towels.
Turn the Power Switch to the OFF position.
Set the Battery Amp. Hr. Selector Switch to the "5.5 to 9.0"
position.
Set the Timer to the position indicated by the Honda Battery
Tester: RED -3. RED -2. or YELLOW -1. If you are charging a
new battery, set the switch to the NEW BATT position.
(1) BATTERY
®®
.
~
DOD
®®
!1!l •
Attach the clamps to the battery terminals; RED to Positive.
BLACK to Negative.
CAUTION
• Connect the battery cables only when the Power Switch
is
OFF.
Turn the Power Switch to the ON position.
When the timer reaches the "Trickle" position, the charging
cycle is complete. Turn the Power Switch OFF and disconnect
the clamps.
15-6
NEW
BATT
YELLOW
- - I I - I . . " ' }
-1
r-I---...,
RED