Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 158

FRONT WHEEL/SUSPENSION/STEERING
To balance the wheel, install wheel weights on the highest
side of the rim, the side opposite the chalk marks. Add just
enough weight so the wheel will no longer stop in the same po-
sition when it's spun.
Do not add more than 60 grams to the front wheel.
Wheel bearing
Turn the inner race of each bearing with your finger. The bear-
ings should turn smoothly and quietly. Also check that the
bearing outer race fits tightly in the hub.
Remove and discard the bearings if the races do not turn
smoothly, quietly, or if they fit loosely in the hub.
NOTE
• Replace hub bearings in pairs.
BEARING REPLACEMENT
Remove the brake disc mounting bolts and discs.
Remove the dust seal from both sides.
Remove the speedometer gear retainer.
NOTE
If the bearings are removed, they must be replaced with
new ones.
Install the bearing remover head into the bearing.
From the opposite side install the bearing remover shaft and
drive the bearing out of the wheel.
07746-0050100
07746-0050600
TOOLS:
Bearing remover shaft
Bearing remover head, 20 mm
12-9