Air Cleaner Case - Honda 88-91 NT650 HAWK GT Serviceanleitung

FUEL SYSTEM
AIR CLEANER CASE
REMOVAL
NOTE
The air cleaner case can be removed without removing the
case cover removal.
Remove the seat and fuel tank.
Remove the air cleaner case mounting bolt.
Loosen the air cleaner connecting tube band screws and dis-
connect the crankcase breather and air cleaner case drain
tube.
Remove the air cleaner case.
Install the air cleaner case in the reverse order of removal.
Disconnect the air hoses (carburetors-to-sub-air cleaner cov-
er).
Remove the sub-air cleaner mounting bolt and cover and
remove the element.
SUB-AIR CLEANER ELEMENT
Remove the following:
- seat (page 13-25) and fuel tank (page 4-3)
- air cleaner case
,
.
Wash the element in non-flammable or high flash point sol-
vent, squeeze out the solvent thoroughly. and allow the ele-
ment to dry.
Soak the element in gear oil (SAE #80-90) and squeeze out
the excess.
Reinstall the element and cover, and tighten the bolt.
Reconnect the air tubes from the carburetors.
4-4
(1 )
WASH IN
SOLVENT
<>(i<>
i
j
(2)
SQUEEZE OUT
SOLVENT
THOROUGHLY
(3)
DRY
(4) (5)
GEAR OIL SQUEEZE OUT
(SAE #80-90) EXCESS OIL