Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 86

ENGINE REMOVAL/INSTALLATION
Install the swingarm pivot nut and tighten it to the specified
torque.
TORQUE: 65 N'm (6.5 kg-m. 47 ft-Ibl
Install the rear engine upper mounting adjusting bolt.
Turn the mounting adjust bolt clockwise fully to seat the
engine mount.
Tighten to the specified torque.
TORQUE: 11 N'm (1.1 kg-m. 8 ft-Ibl
Install the lock nut onto the adjusting bolt.
TORQUE: 55 N'm (5.5 kg-m. 40 ft-Ibl
Install the rear engine upper mounting bolt and tighten it to the
specified torque.
TORQUE: 40 N'm (4.0 kg-m. 29 ft-Ibl
Tighten all the fasteners to the torques given on page 6-1 and
2.
NOTE
Route the wires and cables properly (Section 1).
Fill the crankcase to the proper level with the recommended
oil (page 2-1).
Fill the cooling system (page 5-3l.
Perform the following inspection and adjustments:
Throttle operation (page 3-4l.
Clutch (page 3-15).
6-6