Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 204

HYDRAULIC BRAKE
ASSEMBLY
Coat new piston seals and dust seals with clean brake fluid
and install them in the caliper.
Install the pistons with the dished ends toward the pads.
Install the pad spring on the caliper as shown.
Apply silicone grease to the inside of the boot, and install it.
Install the pads and pad pins in the caliper.
Install the caliper assembly over the brake disc so that the disc
is positioned between the pads.
CAUTION
• Be careful
nol 1o
damage rhe pads.
Install and tighten the caliper mounting bolts.
TORQUE: 27 N·m (2.7 kg-m, 20 ft-Ibl
Tighten the pad pins and install and tighten the pad pin plug
(page 14-5).
Connect the brake hose to the caliper with the oil bolt and two
new sealing washers.
TORQUE: 30 N'm (3.0 kg-m, 22 ft-Ibl
Bleed the air from the brake system (page 14-3),
14-12
(2) DUST SEALS