Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 144

CRANKSHAFT/TRANSMISSION
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07746-0010400
07746-0041000
TOOLS:
Right mainshaft bearing
Driver
Attachment,
52
x
55
mm
Pilot,
22
mm
Right countershaft bearing
Driver
Attachment, 42 x 47 mm
Pilot,
20
mm
Right crankcase "(3) COUNTERS HAFT BEARING
Remove the mainshaft bearing set plate and drive the counter-
shaft bearing, mainshaft bearing and shift drum bearing out of
the crankcase.
Apply a locking agent to the threads of the mainshaft bearing
set plate <lttaching bolt.
Install the set plate aligning the edge of the set plate with the
slot on the bearing outer and tighten the bolt securely.
INSPECTION
(1) 10 mm STUD BOLT HOLES
Crankcase studs
Check that the studs are tight. If any are loose, remove them,
clean their threads with contact cleaner, then reinstall
tn~m
using Honda Anaerobic Thread Lock, or equivalent.
EM
E~
oco
" I
~.q-
I~
00 CO
CO'
co
~-
~
E"
E~
0 "
001
~oo
10
000
""':
~-
(1) 8 mm STUD BOLT (2) 10 mm STUD BOLT
TORQUE: 8 mm stud bolt:
20-30 N'm (2.0-3.0 kg-m, 14-22 ft-Ibl
10 mm stud bolt:
30-50
N·m
(3.0-5.0
kg-m,
22-36
ft-Ibl
After installing, be sure to measure the distance from the top
of each stud to the crankcase surface.
Tighten the stud bolts to the specified torque.
11-13