Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 165

FRONT WHEEL/SUSPENSION/STEERING
ASSEMBLY
Before assembly, wash all parts with a high flash point or non-
flammable solvent and wipe them off completely.
(16) DUST SEAL (17) FORK TUBE
(15) STOP RING \ ,------,
1141 OIL SEAL
~
/
1131 BACK-UP RING
~
1121 SUOER
BUSHIN~
Assemble the rebound spring onto the piston.
Insert the piston assembly into the fork tube.
Place the oil lock piece on the end of the piston and insert the
fork tube assembly into the slider.
(2) FORK TUBE CAP
~
I
(2) OIL LOCK PIECE
Place the fork slider in a vise with soft jaws or use a shop towel
to avoid damaging the slider.
Clean and apply a locking agent to the socket bolt threads and
screw the bolt into the piston.
Temporarily install the fork spring and cap to tighten the
socket bolt.
Tighten the bolt with a 6 mm hex wrench.
TORQUE: 17 N'm (1. 7 kg-m, 12 ft-Ibl
12-16