Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 194

HYDRAULIC BRAKE
TORQUE VALUES
Front master cylinder holder bolt
Rear master cylinder mounting bolt
Brake oil bolt
Brake reservoir screw
Caliper bleed valve
Front caliper mounting bolt
Front caliper pin bolt
Rear caliper mounting bolt
Rear caliper pivot bolt
Rear caliper pad pin
Caliper pad pin plug
Torque rod bolt
Front disc retaining bolt
Rear disc retaining bolt
Rear disc retaining bolt lock nut
TOOL
Special
Snap ring pliers
TROUBLESHOOTING
Brake lever/pedal soft or spongy
Air in hydraulic system
• Low fluid level
Hydraulic system leaking
Brake lever/pedal too hard
Sticking piston(sl
Clogged hydraulic system
Pads glazed or worn excessively
Brake drag
Hydraulic system sticking
Sticking piston(s)
Clogged hydraulic system
Incorrect pedal adjustment
Caliper slide pins sticking
• Disc or wheel misaligned
14-2
12 N'm (1.2 kg-m, 9 ft-Ibl
12 N'm (1.2 kg-m, 9 ft-Ibl
30 N'm (3.0 kg-m, 22 ft-Ibl
1.5 N'm (0.15 kg-m, 1.4 ft-Ibl
6 N'm (0.6 kg-m, 4.3 ft-Ibl
27 N'm (2.7 kg-m, 20 ft-Ibl
28 N'm (2.8 kg-m, 20 ft-Ib)
27 N'm (2.7 kg-m, 20 ft-Ib)
22 N'm (2.2 kg-m, 16 ft-Ib)
17 N'm
(1.
7 kg-m, 12 ft-Ib)
2.5 N'm (0.25 kg-m, 1.8 ft-Ibl
35 N'm (3.5 kg-m, 25 ft-Ibl
40 N'm (4.0 kg-m, 29 ft-Ibl Apply a locking agent to the threads
35 N'm (3.5 kg-m, 25 ft-Ibl
9 N'm (0.9 kg-m, 7 ft-Ib)
07914-3230001
Brakes grab
Pads contaminated
• Disc or wheel misaligned
Brake chatter or squeal
Pads contaminated
Excessive disc runout
Caliper installed incorrectly