Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 219

BATTERY/CHARGING SYSTEM
Remove the seat and rear cowling (page 13-25l.
Disconnect the main fuse connector and remove the main
fuse.
Reconnect the connector securely.
Connect the tester as shown.
CAUTION
Be careful not to let the battery positive cable contact the frame
while testing.
Restart the engine and allow it to idle, then increase the engine
speed gradually.
The voltage and amperage should be controlled as specified
below:
STANDARD:
13.5-15.5 V/0.5
A
(3,000
rpm)
(20 0
C/68°Fl
(3) STARTER
RELAY
ES:J
A
REGULATOR/RECTI FI ER
SYSTEM INSPECTION
Remove the seat and rear cowling.
Disconnect the 3P (WHITE) and 4P (BLACK) regulatorlrectifier
connectors.
Check the connectors for loose or corroded terminals.
If the regulated voltage reading was out of specification,
check the circuits between the connector terminals (wire har-
ness side and alternator side) following the chart on next page.
NOTE
The regulator/rectifier is semiconductorized unit; the speci-
fied tester. If a different tester is used the test results will
be out of specification.
You'll get a false reading if your finger touches the tester
probes.
If the pointer of the tester fails to swing to zero when the
adjusting knob is turned fully clockwise or counter-
clockwise, replace the tester dry battery.
15-8