Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 197

BRAKE PADS/DISCS
FRONT BRAKE PAD REPLACEMENT
-'------------
Inhaled asbestos fibers have been found to cause respiratory
disease and cancer. Never use an air hose or dry brush to clean
brake assemblies. Use an OSHA-approved vacuum cleaner or
alternate method approved by OSHA designed to minimize the
hazard caused by airborne asbestos fibers.
NOTE
Always replace the brake pads in pairs to assure even disc
pressure.
'88 Only:
Remove the cotter pin.
'88 and After '88:
Remove the pad pin plug and loosen the pad pin.
Push the pistons' all the way in to allow installation of new
brake pads.
NOTE
Check the brake fluid level in the reservoir as this operation
causes the level to rise.
Pull the pad pin out of the caliper and remove the brake pads.
Insert the new brake pads.
Install the pad pin by pushing the pads against the caliper to
depress the pad spring.
Tighten the pad pin.
TORQUE: 17 N'm /1.7 kg-m, 12 ft-Ibl
Install the pad pin plug.
TORQUE: 2.5 N'm (0.25 kg-m, 1.8 ft-Ibl
HYDRAULIC BRAKE
14-5