Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 28

LUBRICATION
OIL FILTER CHANGE
Drain the engine oil (page 2-31.
CAUTION
• Do not replace the oil filter when the exhaust system is hot.
Remove the drive sprocket cover (page 8-21.
Remove the oil filter with a filter wrench.
TOOL:
Oil filter wrench 07HAA-PJ70100
Apply oil to the new oil filter O-ring and install the new oil filter.
Tighten the oil filter with a filter wrench.
TORQUE: 10 N'm (1.0 kg-m. 7.2 ft-Ibl
Fill the engine with recommended oil (page 2-3).
OIL PRESSURE CHECK
Remove the oil pressure switch cover and disconnect the
switch wire.
07510-4220100 or
equivalent commercially
available in U.S.A.
07506-3000000 or
equivalent commercially
available in U.S.A.
Oil pressure gauge
Warm the engine up to normal operating temperature (approxi-
mately 80
o
C/176°F).
Stop the engine.
If the engine must be running to do some work, make sure the
area is well-ventilated. Never run the engine in an enclosed
area.
The exhaust contains poisonous carbon monoxide gas that may
cause loss of consciousness and lead to death.
Remove the oil pressure switch and connect an oil pressure
gauge attachment and gauge to the pressure switch hole.
Check the oil level.
TOOLS:
Oil pressure gauge attachment
-'-----------
Start the engine and check the oil pressure at 6.000 rpm.
Oil PRESSURE:
441 kPa (4.5 kg/cm
2 •
64 psi) at 6.000 rpm (80 0 C/176°Fl
Stop the engine.
Apply 3-BOND@ sealant or equivalent to the pressure switch
threads and install.
TORQUE: 12 N'm (1.2 kg-m. 9 ft-Ibl
Connect the oil pressure switch wire and start the engine.
Check that the oil pressure warning indicator goes out after
one or two seconds. If the oil pressure warning indicator stays
on. stop the engine immediately and determine the cause.
(2) OIL
PRESSURE
GAUGE
~~.....,~
2-4