Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 22

GENERAL INFORMATION
NOISE EMISSION CONTROL SYSTEM
TAMPERING WITH THE NOISE CONTROL SYSTEM IS PROHIBITED: Federal law prohibits the following acts or the causing
thereof: (1) The removal or rendering inoperative by any person, other than for purposes of maintenance, repair or replace-
ment, of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or
delivery to the ultimate purchaser or while it is in use; or (2) the use of the vehicle after such device or element of design has
been removed or rendered inoperative by any person.
AMONG THOSE ACTS PRESUMED TO CONSTITUTE TAMPERING ARE THE ACTS LISTED BELOW:
1. Removal of, or puncturing of the muffler, baffles, header pipes or any other component which conducts exhaust gases.
2. Removal of, or puncturing of any part of the intake system.
3. Lack of proper maintenance.
4. Replacing any moving parts of the vehicle, or parts of the exhaust or intake system, with parts other than those specified
by the manufacturer.
EMISSION CONTROL INFORMATION LABELS
An Emission Control Information Label is located on the rear fender as shown. It contains basic tune-up specifications.
A.I
v~
VEHIClE EMISSION CONTROl. INFORMATION ~AT£
~IlDA MOTOR CO., LTD.
THIS VEHICU HAS
II((Jl
ADJUSTED TO
IMPROVE EMISS. CONTROL PERFORIlANCE
WHEN OPERATED AT HIGII ALTITIIlE.
ALTITI& PERfORMANCE ADJUSTMEIIT INSTRUCTIONS
ARE AVAILABLE AT 'lUI AUTHORIZED HONDA DEALER.
.~.
-(1)
EMISSION CONTROL
~
INFORMATION
~ UPDATE LABEL
----
.......
. /
EMISSION CONTROL INFORMATION UPDATE LABEL
After making a high altitude carburetor adjustment (Page 4-151. attach an update label on the left sub-frame upper pipe.
Instructions for obtaining the update label are given in Service Letter No. 132.
.----::::
1-18