Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 13

GENERAL INFORMATION
CABLE
&
HARNESS ROUTING
Note the following when routing cables and wire harnesses:
• A loose wire. harness or cable can be a safety hazard. After
clamping, check each wire to be sure it is secure.
• Do not squeeze wires against welds or clamps.
• Secure wires and wire harnesses to the frame with their re-
spective wire bands at the designated locations. Tighten
the bands so that only the insulated surfaces contact the
wires or wire harnesses.
o
X
Q
• Route harnesses so they are neither pulled taut nor have ex-
cessive slack.
• Protect wires and harnesses with electrical tape or a tubing
if they contact a sharp edge or corner. Clean the attaching
surface thoroughly before applying tape.
o
~
• Do not use a wire or harness with broken insulation. Repair
by wrapping them with protective tape or replace them.
• Route wire harnesses to avoid sharp edges or corners. Also
avoid the projected ends of bolts and screws.
• Keep wire harnesses away from the exhaust pipes and
other hot parts.
• Be sure grommets are seated in their grooves properly.
• After clamping, check each harness to be certain that it
does not interfere with any moving or sliding parts.
• After routing, check that the wire harnesses are not twisted
or kinked.
• Wire harnesses routed along the handlebars should not be
pulled taut, have excessive slack, be pinched by or interfere
with adjacent or surrounding parts~n all steering positions.
• Do not bend or twist the control cables.
Damaged control cables will not operate smoothly and may
stick or bind.
0: CORRECT
x: INCORRECT
1-9