CYLINDER HEADIVALVES
Remove the 2 mm pin holding cam chain tensioner wedge A.
NOTE
Be careful not to let the
2
mm pin fall into the crankcase.
Do not forget to remove the 2 mm pin before installing the
cylinder head cover.
CYLINDER HEAD COVER INSTALLATION
Clean the gasket and apply contact cement to the gasket
groove.
Install the cylinder head cover, rubber washer, washer cover
and cylinder head cover bolts.
Tighten the cover bolts.
TORQUE: 10 N·m (1.0 kg-m, 7.2 ft-Ibl
Connect the water hose to the water pipe and install the spark
plug caps.
Install the following parts:
-
carburetors (page 4-191
-
air cleaner case (page 4-4)
-
fuel tank (page 4-31
Fill the cooling system (page 5-3).
9-20
(2)
HEAD
COVER