Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 154

INSTALLATION
Install the right handlebar onto the fork tube, aligning the pin
on the bottom of the handlebar holder with the cut-out in the
fork bridge. Install the retainer ring. Tighten the handlebar
pinch bolt.
TORQUE: 27 N'm (2.7 kg-m. 20 ft-Ib)
Align the locating pin on the right handlebar switch with the
hole in the handlebar.
Apply clean grease to the throttle cables and apply clean oil to
the throttle pipe sliding surface and connect the throttle cables
to the throttle pipe.
Slide the throttle pipe onto the handlebar.
Install the right grip end weight and tighten the screw.
(2)
MASTER CYLINDER
(6)
PINCH
BOLT
------.~~.((
Place the front brake master cylinder on the handlebar and in-
stall the master cylinder holder with the "UP" mark facing up.
FRONT WHEEL/SUSPENSION/STEERING
Align the end of the holder with the punch mark on the handle-
bar. Tighten the upper holder bolt first, then tighten the lower
bolt.
TORQUE: 12 N'm (1.2 kg-m, 9 ft-Ibl
Connect the front brake switch wire.
Install the right handlebar switch mounting screws.
Tighten the front screw first, then tightne the rear screw.
Install the throttle cables to the carburetor and adjust the
throttle grip free play (page 3-5).
Install the right rear-view mirror into the master cylinder hold-
er.
12-5