Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 208

HYDRAULIC BRAKE
DISASSEMBLY
Remove the pad spring, boots and collar from the rear brake
caliper.
Place a shop towel over the piston, position the caliper with
the piston down and apply small squirts of air pressure to the
fluid inlet to remove the piston.
------------
Do not use high pressure air or bring the nozzle too close to the
inlet.
Push the dust and piston seals in and lift them out.
Wash the caliper cylinder, seal gooves and caliper piston with
clean brake fluid.
CAUTION
• Be careful not to damage the piston sliding surface.
INSPECTION
Check the caliper piston for scratches, scoring or other dam-
age.
Measure the caliper cylinder I.D.
SERVICE LIMIT: 38.24 mm (1.505 in)
Measure the caliper piston
a.D.
SERVICE lIMIT:.38.11
mm
(1.500 in)
14-16